Skip to content
- Low detection limit CO without CO2 interference
- Temperature controlled at 50°C
- Low drift
- Pressure compensated
- Different interfaces (RS232, CANbus,Analog
- MARS-Tool (Datalogger and Controlsoftware)
Read More
- Rugged sensor design
- Low power consumption <2W @ 24V
- Different Interfaces (RS232, CANbus)
- Low drift
- MARS-Tool (Wi.Tec Software)
Read More
Read More
Read More
- Resistant to corrosive gases
- Fast response time
- Applicable for continuous measurements
Read More
- DN 04/06; 1 bar, 10 m
- (Viton hose)
Read More
- On request you will always receive the matching cables to your module for immediate integration into your system.
- Also we offer CAN dongle for CANbus communication.
Read More
- Pump head PVDF
- Diaphragm PTFE
- Valves and seal FFKM
- Brush motor, 24 V DC, 2-wire
- Gas flow rate 0 - 8 l/min
- Hose connection 4 / 6 mm
Read More
- 4/6mm tube connector
- Flowrate 0-4 l/min
- Small volume of 110cm3
- Pressure drop @ 1l/min less 6mbar
Read More
- Modbus RTU
- Baudrate 115200
- RJ45 connector
- Additional RS232 interface
Read More
- For thermal insulation
- Temperature controlled up to 55°C
- Optionally ULTRA.sens® or INFRA.sens®
- With dust filter
- Temperature range 5°C - 40°C
Read More
- Rugged sensor design
- No cross-sensitivity to CF4
- Low power consumption <2W @ 24V
- Different Interfaces (RS232, CANbus, Analog)
- Pressure compensated (600-1200 mbar)
- Inklusive MARS-Tool (Wi.Tec Software)
Read More